 |
| "Honenbru " |
Kimmo Huosionmaa
Was The Honenbru “UFO” Was it created by Nazis or Lockheed Martin is the key question because some of those projects are mentioned made by the Nazis, because the military secrets wanted to cover, and that was the reason for rumors, that Nazis had the UFO. The mission of those claims about co-operation with Nazi-criminals was to close the mouths of the top military specialists, who worked in those projects.
And of course, the rocket science wanted to abandon for the Soviet Union. The Honenbru was the saucer-shaped aircraft, and somebody thinks that the 70 meters diameter disk existed only in the paper, and the question about this craft was making the ultimate fighter and attack aircraft, what had revolutionary aerodynamic capacities.
 |
| Avro Avrocar |
The team what worked with that radical aircraft design created the smaller craft known as Avro Avrocar, and the model of that craft had five motors which of four are horizontal and one is vertical. They forgot that If the horizontal motors will start too early, will that cause the catastrophe.
The Shape of the vehicle is actually like hamburger or raindrop, and this shape is taken from nature. That aircraft had the capacity to fly high speed and make sudden movements on the sideways. But the Hypersonic disk is not always been the purpose of this craft. The original purpose was to make the cannon platform, what would have the excellent capacity of movements, because it was heavier than air.
As the propulsion system was used the combination of jet and rocket engines. When the craft would rise too high for the jet engines, this aircraft would transfer to rocket flight. Also, exotic propulsion systems might be tested. Those systems were laser, WARP or ion motors.The problem with the ion-motors is, that if the ion burst will be targeted to the electric circuits, the electric equipment what is connected to this circuit would be destroyed. Also, the most dangerous “zero-point” propulsion systems were planned.
One of the most brilliant ideas of flying the disk-shaped aircraft was used the powerful microwaves for flying this model. The microwaves must be very powerful if they wanted to rise the craft from the ground. If that microwave will hit any target, it will melt immediately. The laser was probably though used for propulsion, in the way there was a carbon stick in the middle of the craft. Then the lasers will heat this stick, and then the overheated air will pull this craft upwards.
The weight of the disk was the problem, and that’s why the engineers made Avro Avrocar system, for testing the capacity of this system. The power source of the aircraft was the very bad problem with the power sources, because those motors needed extreme high voltage electric circuits and the power must create by the nuclear reactor, what uses very highly enriched nuclear isotopes for fuel.
Also, the artificial nuclear material was planned to use for creating the power for that magnificent aerial vehicle. There were planned propels on the edge of the disk for guarantee the soft landing in the case, that this vehicles motor will stop. I think that Honenbru or Avrocar could revolutionize the thinking of the aerodynamics, but those projects were too advanced for the time when they were made.
https://en.wikipedia.org/wiki/Avro_Canada_VZ-9_Avrocar
https://www.youtube.com/watch?v=bLDqzx5Koyw
https://www.youtube.com/watch?v=0EtFOEkf75E
Comments
Post a Comment